www.hearandlearn.com.au
UConnect, 955, Redcat, Topcat & SoundHouse are part of the
www.hearandlearn.com.au
technology family.
Offices Australia wide (03)93709355
1
2
3
4
5
Hear and Learn UConnect Mini
Installation of UConnect Mini
B Screws
Basket Rim
Basket Rim
Using the B screws, secure the basket to the studs. Make sure the rim of the basket
overhangs the front of the studs by the same thickness as the wallboard being used.
For example, if you are using 10mm Gib Board, ensure that the rim sits out by 10mm.
See pictures above.
The basic installation requires mounting basket to the horizontal and vertical
studs. NOTE: Floating clips will need to be used in the corners that are not
being secured to a stud (usually only one corner).
Insert the basket into the wall making
sure that the frame is sitting on top of
the wallboard.
(a)
Secure with the floating clip/s
(b)
Using the B screws, secure to the studs.
After the wallboard has been installed with a cut
out for the basket (and plastering, if required,
has been completed), attach the frame.
(a)
Remove the basket from the wall
(b)
Using the C screws, attach the frame to
the basket the corners that will be fixed
to the studs.
(c)
On the corners that are NOT fixed to a stud
you will need to use a floating clip. Before
you use it, you will need to thread the clip
using the A screw. Place the clip against the
back of the hub and screw the A screw
through the frame, hub and clip.
Connect the outlets/power points ensuring
you follow current electrical guidelines and
regulations.
Connect the UConnect Mini front plate lid
and the cable cover.