M
IC I
N
10
Manual
Personal Listener Instructions
Connect the microphone into the MIC IN socket on the receiver. Extend the
microphone cable and place the microphone near to the sound source you want to
amplify. Ensure the volume is set to off, switch on the receiver and adjust the volume
and tone to your required levels. If using the neckloop system place the neckloop over
your head, set your hearing aids to the T setting then adjust the volume to your
preferred level. The microphone may also be clipped on a pocket as shown for use for
general conversation
! "#
LINE IN
To use the receiver as a wired listener plug one end of the stereo patch lead into the
LINE IN or MIC IN socket on the receiver and connect the other end to an audio
source such as PC, Radio, MP3, etc. Ensure the volume on the receiver is set to off,
then switch on the receiver and adjust the volume and tone to your required levels.
The microphone can also be used to help amplify people's voice coming through the
speaker of a telephone. Simply connect the microphone and hold it against the
telephone speaker then increase the volume with the volume wheel on the receiver
to your required level.
05
7
Power adapter
、
8
Balance adjusting driver
、
(headset system only)
9
Manual
、
10
、
Earbuds 2 sets, headset system only
Manual
