2
Hearth & Home Technologies • RC150 User Guide • 2326-981 Rev. B • 10/16
Please contact your Hearth & Home Technologies
dealer with any questions or concerns.
For the location of your nearest
Hearth & Home Technologies dealer,
please visit www.hearthnhome.com.
This equipment complies with part 15 of FCC RF Rules. Op-
eration is subject to the following two conditions:
1) This device may not cause interference and
2) This device may accept any interference, including interfer
-
ence that may cause undesired operation of the device.
CAUTION! Risk of burns! Appliance surfaces are hot
when operating and during cool down. Use care and wear
gloves when opening the front and accessing compo-
nents inside the appliance.
Turn off power to the appliance (if back-up batteries
are not installed):
• If the appliance comes equipped with a wired-wall switch,
use that to turn it off.
•
Alternately, you can also locate the house circuit breaker
for appliance and turn it off.
Manual Fireplace Shutoff
In the unlikely event that the wall switch malfunctions and
will not turn off the fireplace, call your dealer for service
assistance. In the meantime, turn off your appliance by
performing the following actions:
DANGER
HOT GLASS
WILL
CAUSE BURNS.
DO NOT TOUCH
GLASS
UNTIL COOLED.
NEVER
ALLOW CHILDREN
TO TOUCH GLASS.
A barrier designed to reduce the risk of
burns from the hot viewing glass is provided
with this appliance and shall be installed for
the protection of children and other at-risk
individuals.
Symptom
Possible Cause
Corrective Action
The appliance does not respond to
commands from the wireless wall switch
and the LED does not blink.
Batteries are depleted.
Verify batteries are new.
Batteries are incorrectly installed.
Verify batteries are installed in correct orientation
as shown on battery receptacle.
The appliance does not respond to
commands from the wireless wall switch but
the LED blinks.
The appliance does not respond to com-
mands from the wireless wall switch, but
the LED blinks the the switch is touched.
The wireless wall switch is not paired
to the control module.
Call dealer for service.
The wall switch LED blinks even though no
command is given.
Communicating with control module.
This is normal operation. The wireless wall
switch communicates periodically with the con-
trol module to send or receive information.
The wall switch LED blinks constantly once
every 3 seconds.
Low battery indicator.
Replace the batteries in the wireless wall switch
with new batteries.
The appliance turns OFF the flame after
extended periods of operation.
9 hours safety shutdown timer.
This is normal operation. The appliance will au-
tomatically turn the flame OFF after nine hours
of uninterrupted operation See Section 3A.
Frequently Asked Questions/Troubleshooting
