6
04/21
7058-805F
C. Quick Start Guide
1
2
4
5
6
9
3
7
8
10
QUICK START GUIDE
*Before you plug in this appliance, follow these instructions*
Once a fi re has been
established in the unit, leave
the unit burning on the “high”
setting for 30 minutes to allow
the paint to cure.
NOTE:
Odors and vapors
will be released during
this process.
*Open windows in the room
for ventilation*
Remove hang tags from the door glass. Clean the glass. Remove the hardware pack and desiccant
bag from the fi rebox area before your fi rst fi re.
Add pellets to the hopper and
close the lid.
Open the fi rebox door and
make sure the baffl es are
in place.
Close the fi rebox door and
plug the power cord into the
wall receptacle.
Turn the thermostat on.
Turn the thermostat to off .
If the feed tube is empty
or this is the fi rst fi re, add
a handful of pellets to the
fi re pot.
*Do not add extra fuel to
the fi re pot if the feed tube
has already been primed.
Overfi lling the fi re pot will
cause smoky start-ups.
If the fi re dies out after a few
minutes of operation it will be
necessary to push the reset
button to add more fuel.
The stove will feed pellets
for a minute and stop. Once
a fi re starts, the feed cycle
will resume.
NOTE:
Allow 5 minutes for
ignition to take place.
After 30 minutes have passed, turn the thermostat off and allow the unit to cool completely. Open the door
and clean the fi re pot according to the cleaning instructions found inside the hopper lid or owners manual.
Close the door and set the thermostat to a desired temperature. Unit is now ready to resume
normal operation.
