56
Hearth & Home Technologies • B41L-AU Installation Manual • 2570-980 Rev. C • 7/20
3. Install Log #1 by locating the back left tab behind the
burner. Place the log so that the left end is contacting
the tab and pulled forward until it contacts the sheet
metal flange behind the burner. The right end of the
log rests on top of the pilot shield. See Figure 11.4.
4. Place mineral wool on the burner. Mineral wool can
be placed the entire length of the burner, but it must
only be placed between the front row of ports and the
space in front of the burner. The mineral wool should
not cover any ports or fall so that it covers the gap on
either side of the burner. Refer to Figure 11.4.
5. Install Log #3 by resting it on top of Log #1. Log #3
will cross the burner. The tab near the front of the
basepan will rest in the notch in the front tip of the
log. See Figure 11.5.
Note:
When Log #3 is correctly positioned on Log
#1, the left side of the log will be just outside the left
end of the burner. See Figure 11.6.
Figure 11.4 Place Log #1
Figure 11.5 Place Log #3
Figure 11.6 Place Log #3
1
1
11
11
33
33
77
77
MINERAL WOOL
MINERAL WOOL
6. Install Log #6 by placing the right end of the log
against the right log tab. The left end of the log will
contact the back side of the left tab. The back end of
Log #6 will sit on top of Log #7. See Figure 11.7.
Figure 11.7 Place Log #6
7. Install Log #5 by placing the forked end down as
shown in Figure 11.8. One side of the fork will rest
on Log #3 and the other side of the fork will touch the
designated log placement tabs. The other end of the
logs rests on the smooth area on Log #7 as noted in
Figure 11.7. See Figure 11.8.
6
6
11
33
77
SMOOTH AREA FOR LOG #5
SMOOTH AREA FOR LOG #5
