Remotes take 4 AA batteries (not included).
IMPORTANT BATTERY INFORMATION
•
Battery installation and removal should be
performed by an adult.
•
Use only batteries recommended in this
instruction manual.
•
Be careful to install the batteries with the correct
polarity, as indicated.
•
Be sure to insert batteries correctly according to (+)
and (-) symbol located in the battery compartment.
•
Do not mix old and new batteries, remove all batteries
when replacing.
•
Do not mix alkaline, standard (carbon-zinc), recharge-
able (nickel-cadmium), or different types of batteries.
•
Non-rechargable batteries are not to be recharged.
•
Rechargeable batteries are to be removed from the toy
before being charged and are only to be charged under
adult supervision.
•
Only batteries of the same or equivalent type are to
be used.
•
The supply terminals are not to be short-circuited.
•
Always remove weak or dead batteries from
the product.
•
CAUTION: Do not dispose of battery in fire.
Battery may explode or leak.
Battery must be recycled or disposed
of properly. Do not short-circuit or
dispose of in fire or landfills.
Strobe Ball:
Motion-activated light-up strobe ball flashes when bumped, and will turn
off after 5-10 seconds of no contact. When batteries are exhausted, please
dispose of strobe ball.
To Play:
Make sure
racers are fully
charged.
Turn racers on.
Forward/backward buttons
move the racers in desired
direction.
Open the entrance door, drop racer into the
tube track, close the door and
GO!
Use channel B for
additional vehicles.
Signal light glows
when active.
#733426 Conforms to ASTM-F963 Made in China. ©HearthSong
®
2020. Madison, VA 22727. 1-800-533-4397 HearthSong.com
Troubleshooting:
If your racer is not running, check that:
The switch is turned to ON.
The channel frequency switch on the remote matches the frequency on your racer.
The racer is fully charged.
The batteries in your remote are good.
The remote is pointed to the racer directly within a 9 foot distance.
Other important information:
Turn off both the remote and the racer when not playing.
For maximum speed, keep the wheels on your racer clean. Remove dust and
debris by rolling your racer on a piece of masking tape.
Racers and remote controls work on A or B frequencies. Channel B may be used
for additional vehicles.
If your racer is illuminated but not running:
Check that the pipes are assembled correctly and aligned properly to avoid gaps.
Drive the racer forward and backward repeatedly.
Grip nearby tube and drive the racer at the same time.
Open the pipes at a connector to access and dislodge the racer.
Gently shake the entire track set to make the racer slide inside the pipe.
Turn remotes on
Turn frequency to A.
733426_HSG-TunnelRacer_Instructions.indd 2
7/30/20 9:14 AM
