15
Outdoor Griddles (Models 830-3852, 830-3052, 830-2052)
LP Connection
The Griddle is factory set for LP gas. It comes equipped with an LP hose/regulator assembly for connection
to a standard 20 lb. LP cylinder (Type 1). The LP tank is not included. The griddle system is leak tested. Do not
remove the Regulator/Hose assembly from the product during cart installation.
Connection: LP Hose with a type 1 quick disconnect and regulator. Operating pressure: 11.0"W.C.
Ensure the main valve on the tank is completely closed and all burner knobs are in the OFF position. Although
the flow of gas is stopped when the Type 1 system is disconnected as part of its safety feature, you should
always turn off the LP tank main valve after each use and during transport of the tank or unit.
Insert the regulator inlet into the tank valve and turn the black coupler clockwise until it tightens. Do not over
tighten the coupler. Turn the main tank valve ON and the burner control valves to HI for about 20 seconds to
allow the air in the system to purge. Turn the valves OFF and wait 5 minutes before attempting to ignite the
burners.
When an LP unit is being directly connected to an LP house system, you must follow the natural gas connection
guidelines. The installer must provide the proper gas regulator to reduce the gas pressure to 11" W.C.
Changing the LP cylinder
Ensure the main tank valve is turned OFF and the control knobs are in the OFF position before turning the
coupler counter clockwise to disengage the inlet. Remove the inlet from the tank valve opening.
The LP tank must be changed in a well ventilated place, away from any heat sources (cigarette, electrical
appliances, etc.).
Always check for gas leaks after every LP tank change.
3"
76mm
MIN
Notes:
1. Do not store a spare LP gas cylinder
under or near this appliance;
2.
Never fill the cylinder beyond 80
percent full; and
3. If the instructions in 1 and 2 are
not followed exactly, a fire causing
death or serious injury may occur.
CGA No. 791 connection: “Place dust
cap on cylinder valve outlet whenever
the cylinder is not in use. Only install the
type of dust cap on the cylinder valve
outlet that is provided with the cylinder
valve. Other types of caps or plugs may
result in leakage of propane.”
GAS CONNECTIONS
