Hearthstone Quality Home Heating Products, Inc.
Manchester Model 8330 Pellet Stove
Page 44 of 59
Operation
To Adjust Home and Away Temperature (Programmable Mode)
Action
Step 1: From the main display press
to view the
Home
set temperature or
to view the
Away
set temperature.
Step 2: Press the
to modify the set temperature.
Step 3: Use the
and
buttons to change the temperatures.
Step 4:
Press the
button to confirm the change in the set temperature.
To Turn On or Off
Press the
button to turn the stove on and off in Programmable mode.
Note: The stove will not ignite if the set temperature is already achieved.
Startup Cycle
All of the operation modes use the same startup cycle. Once the startup sequence is initiated, the stove does
not require any user intervention. The entire sequence will take between 10 and 20 minutes depending on the
starting temperature of the stove and type of pellets.
Ignition
The igniter, auger, and exhaust fan turn on immediately when the ignition phase is started. The burn
pot will partially fill. The amount of filling depends on how full the auger is before the stove is started
and the amount of ash and clinkers in the pot. Once the initial amounts of pellets are in the pot, the
auger will stop until the pellets ignite. The unit will smoke for a few minutes as the pellets heat, shortly
followed by visible flames.
The convection fan will start at the completion of the start phase. When ignition is complete, the pellets
will begin to feed to maintain the fire.
Once the flame temperature in the firebox has reached a specific temperature, the unit will progress to
the start phase.
Start
The start phase operates until the flame temperature sensor in the firebox reaches the normal operating
temperature.
Home
70 F
Prog
70 F
Home
65 F
home
65 F
prog
65 F
