Hearthstone Quality Home Heating Products, Inc.
Bristol DX Model 8763
35
Press small flame button to Decrease fan speed. To
turn OFF fan, press small flame button until all 4
speed level bars disappear.
NOTE: 8 seconds after the fan has been set, the
handset will automatically go into temperature control
mode (CSA version). The fan starts 4 minutes after
the gas opens (from OFF or from pilot) at maximum
speed and goes to the displayed level after 10
seconds. The fan stops 10 minutes after the gas is
OFF or at pilot.
MODES OF OPERATION
• Briefly pressing the
SET
button changes
the mode of operation in the following
order:
NOTE: Manual mode can also be reached by
pressing either the large flame or the small flame
button.
•
Manual Mode
Manual flame height
adjustment.
• Daytime Temperature Mode
(Appliance must be in
standby mode; pilot ignited)
The room temperature is
measured and compared
to the set temperature. The
flame height is then
automatically adjusted to
achieve the Daytime Set
Temperature .
Light/Dimmer Mode (Optional)
See discussion above.
Circulating Fan Mode
. See discussion above.
• Nighttime Setback
Temperature Mode
(Appliance must be
in standby mode; pilot
ignited)
The room temperature is
Measured and compared
to the Nighttime Setback
Temperature. The flame
height is then automatically adjusted to achieve the
Nighttime Setback Temperature.
• Timer Mode
(Appliance Must be in
standby mode; pilot ignited)
The Timers P1 and P2
(Program 1, Program 2)
each can be programmed
to go ON and OFF at
specific times. For
instructions see Timer
Programming Mode.
NOTE: The display shows the set temperature every
30 seconds.
SETTING °C/24 HOUR OR
°F/12 HOUR CLOCK
•
Press
OFF
and small flame
button until display changes
from Fahrenheit/12 hour clock to
Celsius/24 hour clock and vice
versa.
