Hearthstone Quality Home Heating Products, Inc.
Bristol Model 8762
33
ON/REMOTE/OFF switch on the Receiver or by the
Remote Control.
With the Manual
switch set to ‘REMOTE’ you have
the option of operating with the remote. Or you can
set the switch to ‘ON’ and the burner will light and
remain at the previous setting used.
Figure 31 - Receiver Switch
You can adjust the flame height via the remote
control, or use the ‘Smart’ mode to let the system
automatically adjust it for you. See the Proflame 2
GTMFS use and installation instructions included
with the Remote transmitter for detailed system
operation instructions.
During the summer non-heating season, switch the
unit “OFF”, and flip the pilot switch to Intermittent
(IPI). This will improve the overall efficiency of the
unit as the heat from the pilot is not wasted. When
putting the unit back into service, replace any
batteries with fresh ones, and refer to the lighting
instructions on page 30.
Note: the unit will produce odors for a short
time when lit after a long period of non-use.
A thorough cleaning of the unit to remove
dust will minimize this effect. Open a window
briefly to help quickly dissipate the odors.
When the unit is first lit, especially when cool, it is
normal to experience some condensation on the
inside of the window glass. This condensation will
burn off within the first few minutes of operation. If
continuous condensation on the window glass or
dripping water from any part of the unit or venting
system (chimney) is noted, immediately discontinue
operation of the unit and contact qualified service
personnel.
To Turn off Gas and Shut Down the
Appliance:
1. Close the shut-off in the gas supply to
the valve.
2. Set the ON/REMOTE/OFF switch to the
“OFF” position.
3. Switch the Pilot mode to IPI mode.
