Hearthstone Quality Home Heating Products, Inc.
Bristol Model 8762
35
Battery Replacement
WARNING: DISCONNECT POWER TO THE UNIT
AND SHUT OFF THE GAS SUPPLY TO THE
VALVE BEFORE REPLACING ANY BATTERIES.
Hearthstone recommends replacing all batteries at
least every season. Keep a supply of good quality
rechargeable
batteries
on
hand
to
ensure
functionality during power outages, and to give the
environment a break.
Remote Transmitter Battery Replacement
You can easily change the Remote Transmitter
batteries by accessing the rear cover plate. Ensure
you orient the batteries correctly as indicated in the
battery compartment.
Receiver Battery Replacement
1. Move the switch to the OFF position. Remove
the cover plate screws and pry the entire plate
with the switch off the receiver’s battery
compartment.
2. Install four new AA batteries. Ensure you orient
the batteries correctly as indicated on the battery
compartment cover.
3. Ensure the switch is still in the OFF position,
align the slider with switch stem and snap the
cover plate back onto the battery compartment.
4. Replace the cover plate screws.
Initializing the Remote Control
Whenever you replace the batteries, you must
synchronize communication between the Receiver
and the Remote Control transmitter.
1. Place the slider switch in the REMOTE position.
2. Insert the end of a paper clip into the hole
marked PRG on the Receiver cover. The
Receiver will beep three times to indicate it is
ready to synchronize with the Remote Control.
3. Install three AAA batteries in the Remote
Control, and push the ON button. The Receiver
will beep four times to indicate the Remote’s
command is accepted and is set to the particular
code of that Remote. The system is now
initialized.
Professional Inspection
Once a year, have the unit, and venting system
inspected by qualified service personnel to ensure
that they are clean, free of obstruction, safe, and in
good working order. If service or maintenance is
required, have qualified service personnel perform it.
If the vent-air exhaust/intake system is disassembled
for cleaning, or any reason, reinstall per the
instructions provided in this manual, or by the
specific venting manufacturer.
As Needed:
Glass and Gasket Replacement
In the event that you need to repair or replace a
cracked or broken glass or worn gasketing, use the
following instructions to replace the components. For
a broken front glass ask for kit 97-58620, for side
glass ask for kit 97-58621 from your Authorized
Hearthstone Dealer. Your Bristol uses a folded flat
fiberglass gasket to make a tight seal between the
glass frame and the firebox. In time, the gasket can
become brittle and compressed and should be
replaced. New gasket material is also available from
your Authorized Hearthstone Dealer. Protect your
hands with work gloves, and wash up later.
1. Allow the Bristol to cool completely. Dismount
the front façade, and the side panels.
2. To dismount the side panels, first remove the
top and front façade. Remove the top front
machine screw while holding the panel, and then
lift the side panel off the stove (
See figure 33
).
Figure 32
– Side Panel Mounting Detail
