Hearthstone Quality Home Heating Products, Inc
CHAMPLAIN DV Model 8301
R
OUTINE
M
AINTENANCE AND
C
ARE
The Champlain requires minimal routine
maintenance and care. The unit should always be
cool and off when cleaned, or serviced.
Once a year the unit and venting system should be
inspected by qualified service personnel to ensure
that they are clean, prevent the accumulation of
dust, lint and other debris, free of obstruction, safe
and in good working condition. To clean the
firebox, set the switch to the “OFF” position, and
turn off the gas to the gas control valve.
When the unit is cool
, open the front door and
carefully remove the decorative fiber log set taking
care not to damage the logs or chip the enameled
cast iron. Clean the pan burner, and carefully
vacuum the entire surface of the log set. Take care
to thoroughly vacuum the ports (slots) on the top of
the pan burner.
With the decorative fiber logs out of the firebox,
fasten the door shut and briefly light the unit
according to
lighting instructions
described on
Page
7.
Check to ensure a flame is burning from each
burner port. The pilot flame should be large enough
to engulf the thermocouple and thermopile
.
Turn the
unit off by setting the switch to
“Off”
, and turning off
the gas control valve.
Allow the unit to cool
.
Check and clean any burner ports that are not
burning, or not burning properly. Clean the burner
ports using a soft brush or vacuum cleaner. Adjust
the pilot flame height if necessary.
Complete the cleaning procedure by carefully
placing the log set back in the firebox as described
on
Page 18.
Re-install the glass assembly and front
façade. Turn on the gas, light the unit, and check
for proper operation.
WARNING! DO NOT USE ABRASIVES WHEN
CLEANING THE GLASS.
R
EPLACING THE
G
LASS
Order kit 93-58015 (complete glass assembly with
frame). To replace the front glass, first shut the pilot
light off. Refer to the Firebox Access instructions on
page 8 to remove the front façade casting and glass
assembly.
1. If the glass is severely broken, first pull the
broken fragments of glass away from the
firebox using heavy-duty gloves.
2. Then remove the glass frame and clean up any
remaining glass fragments.
3. Carefully install the new glass with frame onto
the firebox.
4. Replace the door reversing the steps used for
removal.
WARNING! DO NOT USE SUBSTITUTE
MATERIALS. USE ONLY PARTS SUPPLIED BY
HEARTHSTONE THROUGH AN AUTHORIZED
HEARTHSTONE DEALER.
CAUTION! DO NOT CLEAN THE GLASS WHILE
THE UNIT IS HOT.
Page 22 of 30
