Hearthstone Quality Home Heating Products, Inc
CHAMPLAIN Model 8303
10
Figure 6
– Minimum Snorkel Wall Clearances
Figure 7 - Horizontal Vent Mantle Clearance
Figure 8 - Snorkel Termination Mantle Clearance
The corner clearance for the Champlain 8303
is 4”,
measured from the edge of the firebox to the adjacent
wall.
Venting Components &
Configuration
Do not vent the Champlain jointly with any other solid
fuel or gas appliance. Vent the stove directly to the
outside of the building using a proper termination as
listed in this manual. The only types of venting pipe
approved for use with your Champlain Direct-Vent
stove are those listed in this manual. The venting
configuration diagram is shown in
Figures 9 - 13
.
After determining the proper venting configuration for
your stove, select the vent system that will
accommodate your installation.
CAUTION: ENSURE NO WIRING OR PLUMBING IS
IN THE CHOSEN LOCATION.
CAUTION: DO NOT RECESS VENTING
TERMINATIONS INTO A WALL OR SIDING.
Note:
If you need further direction for installation,
please refer to the venting instructions provided with
the venting components.
Vent Connection
The Champlain Direct Vent Model 8303 is approved
for installation only with the vent connecting
components listed in this manual. Use the following
instructions along with
the pipe manufacturer’s
instructions to complete the installation.
The starter collar is factory installed. Install the rest of
the vent system according to the manufacturer’s
instructions.
Specified Venting Manufacturers
This heater is approved for installation only with the
venting components provided by manufacturers listed
on
this page.
Simpson Dura-Vent, Inc.
P.O. Box 1510
Vacaville, CA 95696-1510
800-835-4429
American Metal Products
(AmeriVent)
8601 Hacks Cross Rd.
Olive Branch, MS 38654
800-423-4270
Selkirk Corporation
1301 W. President George Bush Hwy, Suite 330
Richardson, TX 75080-1139
800-992-8368
