Hearthstone Quality Home Heating Products, Inc
EUROPA Series 8900
23
1.
The valve control module is powered by four “AA” batteries. The batteries are mounted within the Valve
Receiver Module located underneath the fireplace, behind the surround, attached to a slide-out
mounting bracket for easy accessibility.
2. Loosen the thumb screw on the module slide-out mounting bracket by turning counter-clockwise until
the threads are fully disengaged from the base bracket.
3. Rotate the Valve Receiver Module and mounting bracket. Toward you 90 degrees.
4. Slide off the Battery compartment cover.
5.
Install the 4 “AA” batteries, supplied, using the guides inside the battery pack to show you the correct
battery orientation.
6. Replace the battery compartment cover. Rotate the Valve Receiver Module and mounting bracket into
its home position and tighten the thumb screw to secure.
7.
The remote handset is powered by three “AAA” batteries. The access panel is located on the back of
the handset and simply snaps open to provide access to the battery compartment. Install the three
batteries as shown on the label inside the remote control battery compartment.
8. Replace the remote handset access panel.
Installing the Front Glass Panel and Frame with Integrated Screen
After burner media, batteries, and relief doors been installed, the
next step is to replace the front glass panel and frame.
1. Carefully pick up the glass and glass frame with integrated
screen assembly by grasping the sides of the frame and
using your thumbs and fingers to hold the glass in place
within the gasket and frame.
2. With the glass frame (and glass) held at a slight angle
(leaving room for your fingers between the frame and the
firebox) insert the bottom edge of the frame into the frame
retainer located on the bottom front of the fire-box. Take
care to center the frame from left to right.
3. Once the bottom edge is in place, move your fingers out of
the way and press the top of the frame with integrated
screen against the firebox while pushing down to be sure
the frame is fully engaged in the frame retainer.
4. Hold the frame with integrated screen in place with one
hand and insert the four glass frame fasteners along the
top edge of the glass frame. Tighten the fasteners until
they are hand-tight.
5. Tighten each fastener 1/2 turn at a time, working from one
side to the other, until the glass frame has made contact
with the firebox face along the entire top edge. Do not
over-tighten the fasteners as this can put excessive stress on the glass.
6. Replace the Stove front as shown below.
