Hearthstone Quality Home Heating Products, Inc
EUROPA Series 8900
35
Cleaning the Glass
WARNING: Never clean the glass while it is hot. Do not use abrasive cleaners or cleaners containing ammonia.
NOTE: A micro-fiber cleaning cloth and plain water is recommended by the glass manufacturer.
Inspecting the Venting
An inspection of both the inner and outer vent pipes and the vent terminal should be made as part of the annual
service appointment. The venting must have no blockage
and be in good repair. The vent manufacturer’s
instructions may provide specific details on vent inspection. Any vent sections that are disassembled must be
reassembled and sealed as required.
Any safety screen, guard, or barrier removed for servicing an appliance must be replaced prior to
operating the appliance.
Cleaning the Burner and Firebox
During the annual inspection and maintenance appointment, the service person should clean the burner and
firebox. To gain access to the firebox and burner, follow the instructions beginning on pages 17-18 of this
manual.
DO NOT USE A VACUUM CLEANER TO CLEAN THE GLASS BURNER MEDIA.
A vacuum cleaner may be used to clean the metal parts of the firebox. Leave the glass burner media in place.
Use a soft brush to clean the burner glass media. If the burner media does need to be removed, carefully scoop
it off the burner and avoid dropping glass pieces in the air gaps around the burner. Follow the instructions on
page 18 of this manual when replacing the burner media on the burner top.
Air Flow
The EUROPA
utilizes a convection air heat exchange system to maximize heat delivered from the fireplace. It is
important that air flows freely through the convection air system and out the top and side air grills. Do not place
objects under the fireplace that will block the convection air inlet flow or in front of any air outlet.
Synchronizing the Remote and Valve Receiver Module
A code is selected automatically for all Mertik Maxitrol electronics from among 65,000 random codes available.
The receiver must learn the code of the handset, which is performed at the factory. If for any reason your
appliance stops responding to remote commands, it may be necessary to re-sync the two components. To
access the Valve Receiver Module, follow the instruction on pages 20-21. Once you have access to the
Receiver,
This appliance should be inspected before use and at least annually by a qualified
service person. More frequent cleaning may be required due to excessive dust or lint
from carpeting, bedding materials, pets, etc. It is imperative that control compartments
and circulating air passageways of this appliance be kept clean.
