Hearthstone Quality Home Heating Products, Inc.
BARI Model #8180
9.
Important!
Center the glass
and ensure that
the edges of the curved glass are parallel with
the edges of the opening.
10. Reinstall the inner glass frame (limits pressure
on glass from the retainer).
11.
Check glass position again (centered, and
parallel), then screw the glass retainer back on
the door using a crisscross pattern. Tighten the
screws no more than 1/8
th
of a turn after they
seat. (The glass will break at this point if not
positioned correctly. If the glass shifts too much
to one side, you will see the gasket from the
outside)
12. Apply a light film of anti-seize lubricant on the
door’s hinge pins and washer if needed.
13. Install the door.
14. After 5 or 6 fires, check the glass retainer
screws, and retighten if necessary.
Required Glass Kit:
Part Number: 040-057-V
(Glass with gasket applied).
Figure 15: Door assembly
G
LASS
C
LEANING
As fuel gas may contain some impurities; it will be
necessary to clean the inside of the glass
occasionally. Do not use abrasive cleaners.
Scratching the glass will weaken the integrity of the
glass.
Do not clean the glass when hot!
Allow the
glass to cool and apply a mild window cleaning fluid.
Special gas appliance window cleaner is available
from your local Hearthstone dealer.
WARNING: DO NOT OPERATE THIS APPLIANCE
WITH THE GLASS PANEL REMOVED, CRACKED,
OR BROKEN. DO NOT SUBJECT THE DOOR TO
ABUSE, SUCH AS STRIKING OR SLAMMING
SHUT. REPLACEMENT OF THE GLASS PANEL
SHOULD BE DONE BY A LICENSED OR
QUALIFIED SERVICE PERSON.
V
ENTING
The venting system should receive a periodic
examination by a qualified agency. If the venting
system is disassembled for any reason, re-install per
the instructions provided with the venting system, or
in the venting section of this manual, ensuring to
reassemble and reseal the venting properly.
S
TONE
Occasional cleaning is all that is necessary to
maintain the natural beauty of your stove’s
soapstone finish. Clean the soapstone with water, or
any non-abrasive cleaner (window cleaner) and a
soft cloth. Wipe dust from the stone with a clean
cloth. Do not use chemical agents to wash the
stone; do not use waxes or any polishing agents on
the stone.
Take care not to scratch or chip the soapstone. Do
not set items that can scratch or chip the stone on
top of your stove. If you do scratch the stone, you
can use 240 grit sandpaper to easily repair, or blend
in minor scratches
Often, with use and over time, subtle earth tones of
brown, red, and yellow may appear in the
soapstone. This is a natural reaction in the
soapstone. Surface or hairline fractures may also
appear in the stone after a stove is used. Such
changes are normal and do not affect the operation
or the integrity of the stove and do not require
replacement. If you observe a completely broken
stone, contact your dealer for service.
The stone panels on this stove are heavy (150
pounds total). Use a second person to assist in
handling the panels to avoid injury to yourself, or
damage to the panels.
25
