HearthStone Quality Home Heating Products, Inc.
MODENA 8140 Gas-Fired Direct-Vent
22
B
OLTING YOUR
M
ODENA
G
AS
S
TOVE TO A
P
ERMANENT
S
TRUCTURE
When installing the Modena in a mobile home it is required
that you attach it to the structure. To do this, we have
provided a rear attachment kit with the unit. Locate the 2
steel plates and remove them from the packaging. Attach
the first plate to the stove by inserting the two right angled
ends into slots located in the rear of the stove housing.
(See
figure 14 & 15)
Attach the second steel plate to the first one
using the 2 allen screws provided (
See Figure 14 & 15).
Figure 14
Figure 15
Leave the screws loose. Next, level, then slide the rear plate
up tight to the wall. Using the three screws provided, screw
the steel plate to the wall. Once the screws are in place and
the stove is in its proper location, use the provided allen
wrench to tighten the two screws that hold the two plates
together.
H
IGH
A
LTITUDE
I
NSTALLATIONS
For installations from 610-1370 meters (2000-4500ft) the
orifice sizes (DMS) should be 38 for NG and 53 for LP. See
the rating label for more information. For high altitude
installations consult the local gas distributer or the authority
having jurisdiction for proper rating methods. If the
installer must convert the unit to adjust for varying
altitudes, the information sticker (similar to the one shown
below) must be filled out by the installer and adhered to the
appliance at the time of conversion. (
Cet appareil est
equipe pour des altitudes compries entre 0 et 2000pieds (0-
610m) seulment).
