Hearthstone Quality Home Heating Products, Inc.
SANTA FE Model 8761
5
I
NSTALLER
’
S
I
NFORMATION
Codes
Adhere to
ALL
local codes
or, in their absence,
the latest edition of THE NATIONAL FUEL
GAS CODE ANSI Z223.1 (NFPA 54) or
CAN/CGA B149 Installation Code, which can
be obtained from:
AMERICAN NATIONAL STANDARDS
INSTITUTE, INC.
1430 BROADWAY
NEW YORK, NY 10018
OR
NATIONAL FIRE PROTECTION
ASSOCIATION, INC.
BATTERY MARCH PARK
QUINCY, MA 02269
The appliance when installed, must be
electrically connected and grounded in
accordance with local codes or, in the absence of
local codes, with the current NFPA 70-National
Electrical Code or CSA C22.1-Canadian Electric
Code.
A manufactured home (mobile) OEM
installation must conform with the Manufactured
Home Construction and Safety Standard, Title
24 CFR, Part 3280 (U.S.) or Standard for
Manufactured Home Installation, ANSI/NCBCS
A225.1 or Standard for Gas Equipped
Recreational Vehicles and mobile Housing, CSA
Z240.4.CAN/SCA Z240 MH (Canada).
(Installer l’appareil selon les codes ou
règlements locaux, ou, en l’absence de tels
règlements, selon les Codes d’installation
CAN/CGA-B149.)
For installations from 610-1370 meters (2000-
4500 ft.) the orifice sizes (DMS) for natural and
propane gas are 32 and 52 respectively. See
data plate for additional information. For high
altitude installations consult the local gas
distributor or the authority having jurisdiction
for proper
rating methods. If the installer must
convert the unit to adjust for varying altitudes,
the information sticker must be filled out by the
installer and adhered to the appliance at the
same time of conversion.
(Cet appareil est
equipè pour des altitudes compries entre 0 et
2000 pieds (0-610 m) seulement.)
F
IBER
L
OG
S
AFETY
I
NFORMATION
If the decorative fiber logs supplied with the
Santa Fe are damaged, they must be replaced.
Hearthstone supplies replacement parts through
your local Hearthstone dealer. Do not replace
fiber logs, or the embers, with any materials not
approved by Hearthstone Quality Home Heating
Products, Inc.
U
NPACKING AND
I
NSPECTION
Unpack and Inspect for Damage
The Santa Fe is packaged by the manufacturer to
withstand normal shipment without damage.
However, damage can still occur during transit,
so take care to inspect for damage when
unpacking and installing the unit. If any damage,
or a missing part, is detected, immediately
contact your dealer.
Do not install or put into
service a damaged or incomplete heater.
The unit should appear to be square and level.
The sheet metal parts should be smooth and free
of bends or dents. The enameled cast iron
should be free of chips or cracks. If visible, or
concealed damage is found, contact your dealer.
The decorative fiber logs supplied with the Santa
Fe are located in the firebox. Always use great
care when handling the decorative ceramic logs,
as they are very fragile and subject to damage
and breakage. To open the firebox: remove the
front door screw with the supplied Allen
wrench, take care not to chip the enamel, and
swing the door open. Remove the lag bolts,
which fasten the unit to the pallet. Take care not
to chip the enameled legs. Have someone help
lift the stove off the pallet, and set it into place.
Summary of Contents for Santa Fe 8761
Page 24: ...23 07044 2 RATING LABEL...
