Hearthstone Quality Home Heating Products, Inc
STERLING-
Ht
Model 8532
15
A
TTACHING
Y
OUR
V
ENTING
Follow the instructions in either of the 5”x8”
starter kits. If you are attaching the Top Exit kit,
(#95-60320) for vertical v enting configurations,
the instructions will be provided with the kit.
I
NNER
C
OLLAR
:
Locate the 8 screw holes where the inner collar
attaches to the heat exch anger. Attach the inner
collar and gasket with the 8 screws
provided
with the collar.
O
UTER
C
OLLAR
:
Locate the 8 screw holes where the outer collar
attaches to the heat exch anger. Attach the outer
collar and gasket with the 8 screws
provided
with the collar.
You are now ready to install your venting.
1.
Gasket
2.
Inner Starter
3.
Gasket
4.
Outer Starter
V
ENT RESTRICTOR
hen converting the u nit to a top exit, (4”x6”
pipe), a restrictor is supplied with the kit.
supplied with
our restrictor
e
middle of the stove to
position which corresponds to the ap propriate
roximate
locations of the settings 1-3; however it can be
set in any position. Ti ghten the screw in the
desired setting.
Note
:
These positions are based on lab results and can
have some variance.
IF the vent-air intake s ystem is disasse mbled for
any reason, reinstall per the instruction provided
for the initial installation.
The flow of combustion and ventilation air
must not be obstructed.
Loosen the Phillips head screw and rotate th
locator, found on the rear
a
chart setting. Shown below are the app
W
Instructions for installation of the restrictor are
the kit. To adjust y
for maximum flame appearance, first ensure the
unit is cool before touching any part of the stove
or venting. Refer to the Venting Configurations
for recommended restriction plate positions.
Restrictor Plate Setting Locations
