HearthStone Quality Home Heating Products Inc
STERLING Ht Gas-Fired Direct Vent heater
Cet appareil peut être
installé dans un maison
préfabriquée (mobile) déjà installée à d emeure si les
règlements locaux le permettent.
Cet appareil doit être utilisé uniquement avec les
types de gas indiqués sur la plaque signalétique. Ne
pas l’utiliser avec d’autres gas sauf si un kitde
conversion certifié est installé
3" MIN.
Cap
Nipple
To Equipment
Inlet
Tee Fitting
Gas Supply
Inlet
Sediment Trap is required
G
AS
C
ONNECTIONS
A top plate and a side cover must be removed to
access the gas control valve. First re move the gas
control valve knobs, b y grasping the knobs firm ly
and gently pulling straight up o n the knobs. Next
remove the six screws holding the top pl ate on. Two
are located on the sides, a nd four are located on top.
To remove the side cover, loosen the two screws
which have holes in the side for acce ssing. Do not
remove these screws, just loosen them.. Slide the
side cover upward and remove. The gas suppl y line
connection is made to the Sterling’s gas control
valve, located on the back of the unit, in the lower
right corner, using a 3/8" NPT fitting. The pipe must
be sized to provide sufficient gas supply to meet the
maximum demand of the unit. The supply line must
include a manual shut-off valve and union so that the
unit can be disconnected for servicing.
Use of a dedicated sedi ment trap is required by code ,
and by Heart hstone. Damage to com ponents caused
by the lack of a sediment trap is
not covered by
Conditionally approved for purchased mobile home
installation. This appliance may be installed in an
aftermarket permanently located, manufactured
(mobile) home, except where prohibited by local
codes.
This appliance is only for use with the type of gas
indicated on the rating plate. This appliance is not
convertible for use with other gases, unless a
certified kit is used, available through your local
Hearthstone dealer.
16
