HearthStone Quality Home Heating Products Inc
STERLING Ht Gas-Fired Direct Vent heater
log on the ember burner, in t he appropriate
position. It should sit as shown.
5)
Gently place the Twig Log (3) in the firebox, on
the ember burner and agai nst the Right Log (1).
The twig sits in a recess ed part of the e mber
burner, which lines it up, in the appropriate
position. It should sit as shown.
6)
Open the bag of Platinum Bright Embers. Fluff
up the pieces, and spread randomly over the logs
and burners. These em bers will glow brightly
when the unit is running.
7)
Re-install the glass a ssembly by lining up the
three tabs on the bottom of the assembl y with
the three slots on the fire box. Slide t he lower
portion of the glass as sembly into the slots and
push it flush against the firebox. Rotate the clips
into the “loc ked” position. Re-install the front
cast by sliding the upper portion under the lip of
the top and t ilting the bottom in flush with the
glass assembly. It should then slide downward
and be snug in place. Make sure t
he glass
assembly is properly secured to the firebox
before turning the unit on. Be careful not to chip
the enamel when installing the glass assembly or
front cast.
R
EMOVAL OF THE
L
OG
S
ET
Caution
Log set retains heat and can be very hot, if
previously lit!
Allow 1 hour after pilot light is turne d
off before handling.
2
To remove the log set, follow the Installation of
Log Set instructions in reverse.
Place the logs and
in a safe area where they will not be damaged.
C
AUTION
Fragile!
Handle log set with care.
3
18
