Hearthstone Quality Home Heating Products, Inc
STERLING-
Ht
Model 8532
5
I
NSTALLER
’
S
I
NFORMATION
Codes
Adhere to
ALL
local codes
or, in their absence, the
latest edition of THE NATIONAL FUEL GAS
CODE ANSI Z223.1 (NFPA 54) or CAN/CGA B1 49
Installation Code, which can be obtained from:
AMERICAN NATIONAL STANDARDS
INSTITUTE, INC.
1430 BROADWAY
NEW YORK, NY 10018
OR
NATIONAL FIRE PROTECTION
ASSOCIATION, INC.
BATTERY MARCH PARK
QUINCY, MA 02269
The appliance, when inst alled, must be el ectrically
connected and grounded in accordance with local
codes or, in the absenc e of local co des, with the
current NFPA 70-National Electrical Code or CSA
C22.1-Canadian Electric Code.
A manufactured home (mobile) OEM installation
must conform with the Manufactured Ho
me
Construction and Safety Standard, Title 24 CFR, Part
3280 (U.S.) or Standard for Manufactured Ho
me
Installation, ANSI/NCBCS A225.1 or Standard for
Gas Equipped Recreational Vehicles and
mobile
Housing, CSA Z240.4 .CAN/SCA Z240 M H
(Canada).
(Installer l’appareil selon les codes ou
règlements locaux, ou, en l’absence de tels
règlements, selon les Codes d’installation CAN/CGA-
B149.)
F
IBER
L
OG
S
AFETY
I
NFORMATION
If the decorative fiber logs supplied with the Sterling
are damaged, they must be replaced. The
manufacturer, through your local Hearthstone dealer,
supplies replacement parts. Do not replace fiber logs
with any materials not approved by Hearthstone
Quality Home Heating Products, Inc.
U
NPACKING AND
I
NSPECTION
Unpack and Inspect for Damage
The Sterling is packaged by the m anufacturer to
withstand normal shipment without dam
age.
However, damage can still occur during transit, so
take care to inspect for damage when unpacking and
installing the unit. If any damage, or a missing part, is
detected, immediately contact y our dealer.
Do not
install or put into service a damaged or incomplete
heater.
The unit should appear to be square and level. The
sheet metal parts should be smooth and free of bend s
or dents. The ena meled cast iron should be free of
chips or cracks. If visible or concealed damage is
found, contact your dealer.
The decorative fiber logs supplied with the Sterling
are located in the firebox. Alway s use great car e
when handling the decorative fiber logs, as they are
very fragile and subject to damage and breakage. To
open the front, grasp both sides of the front cast
facade, toward the bottom, and lift upward and then
outward. The bottom will slide up an
d out. The
whole piece is then easil y removed. Set the front
aside taking care not to chip or scratch the enamel .
Next, locate the two rotating clips above the glass.
Rotate the clips out of the “locked” position and tilt
the top of the glass outward. Lift the e ntire glass up
and out. The log set can now be
inspected for
damage. To take the unit off the pallet, rem ove the
lag bolts, which fasten th e unit to the pallet. Tak e
care not to chip the enameled legs. H ave someone
help lift the stove off the pallet, and set it into place.
Packing List
1-Sterling Gas-fired Heater containing:
3-Decorative Fiber Logs
1- Bag Platinum Bright Embers
1-AA Battery
1-Owner’s Manual and Warranty Card
1-Thermastat and wire
1-LP Conversion kit
