HearthStone Quality Home Heating Products Inc
STOWE Gas-Fired Direct Vent heater
16
V
ENTING
I
NFORMATION
M
INIMUM
V
ENT
K
IT
97-65001
•
45
°
Elbow
•
90
°
Elbow
•
(2) 9” Straight
•
Round Ceiling Support
Wall Thimble Cover
•
Wall Thimble
•
Horizontal Vent Cap
V
ENTING
C
ONNECTION
1.
The Stowe Direct Vent is approved for
installation only with the vent
connecting components listed on
this
page. Use the following instructions
along with the pipe manufacturer’s
instructions to complete the installation.
2.
Attach the inner starter collar and gasket
to the unit with the eight # 8-32 x 3/8"
Phillips Head self-tapping screws.
NOTE:
If required to use the restriction
plate, please refer to Figure 1 for correct
locations of the additional gasket, restriction
plate, and inner adapter configuration.
Make sure the screw head on the restriction
plate faces into the firebox. This will allow
for future adjustments if needed.
3.
Place the outer starter collar and gasket
onto the back of the stove. Secure the
outer adapter with the eight # 8-32 x
3/8" Phillips Head self-tapping screws
that are provided. Install the rest of the
vent system according to the
manufacturer’s instructions.
1. Gasket 4”
3160-155
2. Inner starter
924HB
3. Gasket 6”
3160-157
4. Outer Starter
924HB
5. Restriction Plate 5950-922
F
IGURE
1. G
ASKET
& S
TOVE
A
DAPTER
I
NSTALLATION
