HearthStone Quality Home Heating Products Inc
STOWE Gas-Fired Direct Vent heater
22
Cet appareil peut être installé dans un
maison préfabriquée (mobile) déjà installée
à demeure si les règlements locaux le
permettent.
Cet appareil doit être utilisé uniquement
avec les types de gas indiqués sur la plaque
signalétique. Ne pas l’utiliser avec d’autres
gas sauf si un kitde conversion certifié est
installé.
E
LECTRICAL
C
ONNECTIONS
NOTE:
OPEN VALVE DOOR ON THE FRONT FOR ELECTRICAL AND GAS
CONNECTIONS.
T
HERMOSTAT
The ON/OFF/T’STAT switch or wall
mounted thermostat controls the Stowe. We
recommend installation of the thermostat for
more comfortable performance, however
you may still override the thermostat by
setting the switch to “ON”. The thermostat
controls the unit by “calling for heat.” The
thermostat turns the unit on when the room
is cold, and turns the unit off once the room
is warmed sufficiently. The thermostat is
controlled by a 750 millivolt DC two-wire
circuit.
R
EMOTE
C
ONTROL
There are two different optional remote
controls. Both of the remote controls are
capable of turning the unit on and off. One
of the optional remotes also allows you to
control the temperature of the stove, (in the
same way the thermostat controls the
heater), from anywhere in the vicinity of the
unit. If “ON” & “OFF” are the only controls
required, Kit #90-56912 can be used. If you
would like to control the temperature via the
remote control, use Kit #90-56914.
Installation instructions are provided with
the kits.
T
HERMOSTAT
P
LACEMENT
The thermostat should be placed in the same
room or living space as the unit. Typically
5’ (1.5m) off the floor and away from any
influences that may cause the temperature in
the vicinity of the thermostat to be
unrepresentative of the room temperature in
general. Such influences might include
strong lighting, a heater vent from the
central heating system, or a nearby drafty
window.
Placement of the thermostat on an inside
wall rather than an outside wall is
preferable. Do not place the thermostat
directly behind or too close to the unit,
otherwise heat from the unit will
immediately satisfy the thermostat and turn
the unit off.
T
HERMOSTAT
W
IRING
The thermostat wire from the unit to the
thermostat can be surface mounted, routed
under the floor, or through walls, etc. The
thermostat should be connected to the unit
using a maximum of 40’ (12m) of insulated
thermostat wire (minimum of 18 Ga.) When
making these connections, position the
thermostat wire so it is directed towards the
Conditionally approved for purchased mobile
home installation. This appliance may be
installed in an aftermarket permanently located,
manufactured (mobile) home, where permitted
by local codes.
This appliance is only for use with the type of
gas indicated on the rating plate. This appliance
is not convertible for use with other gases, unless
a certified kit is used, available through your
local HearthStone dealer.
