Hearthstone Quality Home Heating Products, Inc.
Stowe DX Model 8322
29
Heat Wave Baffle, Log Set, & Screen Placement
CAUTION: FRAGILE! HANDLE LOG SET WITH
CARE. ALWAYS WEAR GLOVES AND SAFETY
GOGGLES WHILE HANDLING THE LOG SET.
WARNING: FAILURE TO POSITION THE PARTS IN
ACCORDANCE WITH THESE DIAGRAMS OR
FAILURE TO USE ONLY PARTS SPECIFICALLY
APPROVED WITH THIS APPLIANCE MAY RESULT
IN PROPERTY DAMAGE OR PERSONAL INJURY.
AVERTISSEMENT. RISQUE DE DOMMAGES OU
DE BLESSURES SI LES PIÈCES NE SONT PAS
INSTALLÉES CONFORMÉMENT À CES SCHÉMAS
ET OU SI DES PIÈCES AUTRES QUE CELLES
SPÉCIFIQUEMENT APPROUVÉES AVEC CET
APPAREIL SONT UTILISÉES.
Place only the ceramic log set supplied with the unit
in the firebox. Do not place any other ceramic logs,
wood logs, or other materials in the firebox. If the
log set is damaged or broken contact your dealer for
replacement. The ceramic logs will last a long time;
however, they will break if subjected to rough or
improper handling. Exact positioning of the log set is
required in order to obtain a pleasing flame pattern
and efficient combustion. Incorrect log placement
may cause carbon build-up; excess thermal stress
on the log set and stove parts, reduced efficiency,
and high levels of carbon monoxide. If the log set
does not fit into the firebox exactly as outlined,
contact your dealer for assistance.
Installation of the Heat Wave Baffle
To install the heat wave baffle and log set, you must
have access to the firebox (for access instructions
see page 16).
1. Remove the Heat Wave baffle from the
packaging.
2. Set the base of the baffle centered on the shelf
in the rear of the firebox.
Figure 27
– Baffle Shelf
3. Lift the front edge of the baffle up to align with
the hole in the bottom of the cast iron heat
exchanger.
Figure 28
– Baffle Mounting Boss
4. Locate the mounting bolt and install it through
the baffle and into the boss on the heat
exchanger.
f i r e - p a r t s . c o m
