HearthStone Quality Home Heating Products Inc
Tucson
Model #8700
11
Figure 3: Burner Flame Pattern
R
EPLACE THE
F
RONT
D
OOR
G
ASKET AS
N
EEDED
Your Tucson uses a 3/8” rope-type
fiberglass gasket to make a tight seal
between the door frame and the firebox. In
time, the gasket can become brittle and
compressed and should be replaced. New
gasket material is available from your
Authorized HearthStone Dealer.
1. Allow the Tucson to cool completely.
Remove the existing gasket by grasping
one end and pulling firmly.
2. Use a wire brush or the tip of a
screwdriver to clean the channel of
remaining gasket.
3. Determine the correct length of the
appropriate-sized gasket by laying it out
in the channel. Allow an extra 1 to 2”
(25-50mm), and mark the spot to be cut.
4. Cut the gasket at the marked spot with a
utility knife. Twist the ends slightly to
prevent the gasket from unraveling.
5. Apply water glass adhesive to the gasket
channel.
6. Starting at one end, press the gasket into
the channel. Insure a good joint where
the gasket ends meet before trimming
any excess. Do not overlap the gasket
ends or leave ends with ragged edges.
7. Firmly and evenly press the gasket to
seat it in its channel.
C
LASS
C
LEANING
If operating with propane, it may be
necessary to clean the inside of the glass
occasionally. Do not use abrasive cleaners.
Do not clean the glass when hot. Allow
glass to cool and apply a window cleaning
fluid.
›
WARNING:
Do not operate this
appliance with the glass panel removed,
cracked, or broken. Do not subject the
door to abuse, such as striking or
slamming shut. Replacement of the glass
panel should be done by a licensed or
qualified service person.
