OWNER’S MANUAL MODEL: 8745 TUCSON Vent-Free HEATER
-13-
LOG SET INFORMATION
CAUTION: Fragile! Handle log set and ember strip with
care. Always wear gloves and safety goggles while
handling the log set and the ember strip.
Log Placement Within The Unit
Only the decorative ceramic fiber log set supplied with the
unit should be placed in the firebox. Do not place other
ceramic logs, real wood logs or other material in the firebox.
If the log set is damaged or broken contact your dealer for
replacement.
If the log set does not set into the firebox exactly as outlined
below, contact your dealer for assistance. Exact positioning
of the log set is required in order to obtain a pleasing flame
pattern and efficient combustion. Incorrect log placement
may cause carbon build-up, excess thermal stress on the log
set and stove parts, reduced efficiency, and high levels of
carbon monoxide.
The decorative ceramic fiber log set will give long service
when in use; however, they will break if subjected to rough
or improper handling. Broken or cracked logs should be
replaced. When removing and replacing the log set from the
unit during routine cleaning or service of the unit, take care
not to damage the logs and to position the log set per
instructions above. Also, take care not to chip the enamel on
the door and door frame when removing and replacing the
log set.
Installation of Log Set
Refer to figures 6 & 7 for log set assembly
1) Open the front door using a 1/8" allen wrench.
Loosen the bolt that fastens the door frame to the
firebox by turning it counterclockwise. Be careful not
to chip enamel when loosening the bolt Pull the door
open by grabbing the top edge of the door frame.
2) Remove the packaging material around the log set
assembly. Be careful not to. damage the log set when
unpacking.
3) Gently place the Rear Log (1) in the firebox
against the center of the back wall.
4) Gently place the Middle Log (2) in the fire box
against the front of the Rear Log. There are slots on
the underside that fit in between the burner tube and
into the burner tube holder. The middle log has two
Figure 6
Figure 7