Hearthstone Quality Home Heating Products, Inc.
Tudor Model #8120
15
thimble. Before attaching the vent termination to
the outside of the house, run a bead of non-
hardening mastic around its’ outside edges, so
as to make a seal between it and the wall.
The
arrow on the end cap should point up
. Secure
the cap to the wall with the appropriate screws.
7. Move the stove and vent pipe into position.
Make sure the 6” vent pipe extends into the
horizontal vent cap a minimum of 1-1/4”). Also
make sure the 6” pipe slides through the blanket
insulation that is tucked inside the wall pass
through thimble.
8. Secure the vent using the straps from the
horizontal vent termination to the interior 6” pipe
with 2 sheet metal screws, keeping the screws
close to the wall thimble as possible. Bend or cut
the excess strapping, so that it is not visible after
the installation is complete.
wall thimble
wall thimble cover (opt
When installing
the wall pass
through you
must add the
insulation
blanket
provided.
6"straight
14" snorkel
23-1/2" If installed
without the base
Figure 7: Components of a typical snorkel installation
Termination
Cap
Wall thimble
Wall thimble cover (option
6"straight
Wallpass
through
insulation
blanket
(REQUIRED)
Figure 8: Components of a minimum horizontal vent
configuration
Centerlines shown are approximate. Please dry
fit your venting and take measurements. Pipe
dimensions will vary by manufacturer and
supplier.
