Hearthstone Quality Home Heating Products, Inc.
Tudor Model #8120
E
LECTRICAL
C
ONNECTIONS
NOTE:
open valve door on the lower front for electrical and gas connections.
T
HERMOSTAT
The ON/OFF/T’stat switch or wall mounted
thermostat controls the Tudor. We recommend
installation of the thermostat for more comfortable
performance, however you may still override the
thermostat by setting the switch to “ON”. The
thermostat controls the unit by “calling for heat.” The
thermostat turns the unit on when the room is cold,
and turns the unit off once the room is warmed
sufficiently. The thermostat is controlled by a 750
millivolt DC two-wire circuit.
R
EMOTE
C
ONTROL
There are two different optional remote controls
available for the Tudor. Both of the remote controls
are capable of turning the unit on and off. One of the
optional remotes also allows you to control the
temperature of the stove, (in the same way the
thermostat controls the heater), from anywhere in
the vicinity of the unit. If “ON” & “OFF” are the only
controls required, Kit #90-56912 can be used. If you
would like to control the temperature via the remote
control, use Kit #90-56914. Installation instructions
are provided with the kits.
T
HERMOSTAT
P
LACEMENT
The thermostat should be placed in the same room
or living space as the unit. Typically 5’ (1.5m) off the
floor and away from any influences that may cause
the temperature in the vicinity of the thermostat to be
unrepresentative of the room temperature in
general. Such influences might include strong
lighting, a heater vent from the central heating
system, or a nearby drafty window.
Placement of the thermostat on an inside wall rather
than an outside wall is preferable. Do not place the
thermostat directly behind or too close to the unit,
otherwise heat from the unit will immediately satisfy
the thermostat and turn the unit off.
T
HERMOSTAT
W
IRING
The thermostat should be connected to the Tudor
using no more than 40’ (12 m) of the provided
insulated thermostat wire. The thermostat wire from
the Tudor to the thermostat can be surface mounted
or routed under the floor, through walls, etc.
Be sure to leave a small coil of additional thermostat
wire behind the Tudor so that the unit can be moved
out of position for servicing and cleaning.
Connect one of the thermostat wires to the gas
control marked
TH
and the other to the yellow wire
coming from the on/off T’stat switch
.
When making
these connections, position the thermostat wire so
that it extends towards the wall behind the Tudor,
then towards the thermostat.
At the thermostat, the wires should be connected to
the two connection screws on the back of the
thermostat per the instructions received with the
thermostat. Take care not to over-tighten the
connection screws and not to damage the internal
parts of the thermostat.
16
