Hearthstone Quality Home Heating Products, Inc.
TUDOR 8120 Gas-Fired Direct-Vent
L
OG
S
ET
I
NSTALLATION
CAUTION: Fragile! Handle log set with care.
Always wear gloves and safety goggles while
handling the log set.
Use only the Log set supplied with the Tudor in the
firebox. Do not place any other logs, wood logs, or
other materials in the firebox. If the log set is
damaged or broken, contact your dealer for
replacement. It must be replaced with the same, or
approved replacement parts. These components
affect the combustion quality and safety of the
heater. The Log set will last a long time, however,
they will break if subjected to rough or improper
handling. Exact positioning of the log set is required
in order to obtain a pleasing flame pattern and
efficient combustion. Incorrect log placement may
cause carbon build-up; excess thermal stress on the
log set and stove parts, reduced efficiency, and high
levels of carbon monoxide. If the log set does not fit
into the firebox exactly as outlined, contact your
dealer for assistance.
L
OG
S
ET
P
LACEMENT
1) If not already so, open the doors on the front of
the unit, and remove the front cast and glass
assembly. To remove the front, grasp both
sides of the front cast facade, and lift upward
and then outward. Set the front aside taking
care not to chip or scratch the enamel. Next,
locate the two rotating clips above the glass.
Rotate the clips out of the “locked” position and
tilt the top of the glass outward. Lift the entire
glass assembly up and out.
2) Gently take the logs out of the accessory box
and remove the bubble wrap from the log set.
Be careful not to damage the log set when
unpacking. There are two logs, a Front and a
Rear.
3) Burner Installation: slide up the two side panels
to make installing the burner much easier, and
avoid damage to the panels or the burner.
Gently place the TEK burner in the firebox.
4) There are two locator tabs on the left side and
one on the right side. Ensure these tabs find the
mating slots in the firebox sides. When installed
it should as in the next image:
TEK Burner
5) Place the Rear Log (1) in the firebox, on the
ember burner. On the underside of the log
there is a cutout that allows the pilot flame to
reach the front burner under the log. Align the
log in the appropriate position. It should sit as
shown in the image below:
Rear log
6) Gently place the Front Log (2) in the firebox, on
the TEK Burner. On the top of the TEK Burner
there is a cutout that allows the Front log to rest
in place. It should sit as shown in the next
image:
Front log
21
