Hearthstone Quality Home Heating Products, Inc.
TUDOR 8120 Gas-Fired Direct-Vent
7) Re-install the glass assembly by lining up the
two tabs on the bottom of the assembly with the
two slots on the firebox. Slide the lower portion
of the glass assembly into the slots and push
the top in against the firebox. Rotate the clips
into the “locked” position. Re-install the front
cast by sliding the upper portion onto the lip of
the top and tilting the bottom in flush with the
glass assembly. It should fit snuggly in place.
Ensure the glass assembly is properly secured
to the firebox before turning the unit on. Be
careful not to chip the enamel when installing
the glass assembly or front and top cast.
R
EMOVAL OF
L
OG
S
ET
CAUTION: The log set retains heat and can
be very hot! Allow 2 to 3 hours after the pilot
light is extinguished before handling.
To remove the log set, follow the Installation of Log
Set instructions in the reverse order.
22
