Hearthstone Quality Home Heating Products, Inc.
Tudor Model #8120
I
NSTALLER
’
S
I
NFORMATION
C
ODES
Adhere to all
local codes
or, in their absence, the
latest edition of THE NATIONAL FUEL GAS CODE
ANSI Z223.1 (NFPA 54) or CAN/CGA B149
Installation Code that can be obtained from:
AMERICAN NATIONAL STANDARDS INSTITUTE,
INC.
1430 BROADWAY
NEW YORK, NY 10018
OR
NATIONAL FIRE PROTECTION ASSOCIATION,
INC.
BATTERY MARCH PARK
QUINCY, MA 02269
A manufactured home (mobile) OEM installation
must conform to the Manufactured Home
Construction and Safety Standard, Title 24 CFR,
Part 3280 (U.S.) or Standard for Manufactured
Home Installation, ANSI/NCBCS A225.1 or Standard
for Gas Equipped Recreational Vehicles and mobile
Housing, CSA Z240.4.CAN/SCA Z240 MH
(Canada).
(Installer l’appareil selon les codes ou
règlements locaux, ou, en l’absence de tels
règlements, selon les Codes d’installation
CAN/CGA-B149.)
I
TEMS
R
EQUIRED FOR
I
NSTALLATION
External regulator (for propane/L.P.G. only)
Piping which complies with local codes
Pipe sealant approved for use with
propane/L.P.G. (resistant to sulfur compounds)
Manual
shutoff
valve
Sediment trap (see page 19)
Tee
joint
Pipe
wrench
Phillips
head
screwdriver
Flat tip screwdriver
7/16-inch
wrench
Other parts as required by local code
*Safety
Glasses
*Gloves
P
ACKING
L
IST
1-Tudor Gas-Fired Heater
1-TEK Burner
2-Decorative TEK Firelogs
4-Refractory Panels
1-Tudor top casting
1-Owner’s Manual
1-Thermostat
1-40’ Thermostat wire
1-Wall thimble Insulation Blanket
1-Warranty Validation Form
Note: Vent kits and components are supplied
separately. Failure to use the venting components
specified by Hearthstone QHHP, Inc. will void your
warranty and could risk a fire.
U
NPACKING AND
I
NSPECTION
Unpack and Inspect for Damage
The Tudor is packaged by the manufacturer to
withstand shipment without damage. However,
damage can still occur during transit; so take care to
inspect for damage when unpacking and installing
the unit. If any damage or missing parts are
detected, immediately contact your dealer
.
Do not install, or put into service, a damaged or
incomplete heater.
The Tudor requires a pilot shield. This shield is
shipped with the unit. Make sure the sure the
shield is installed over the pilot with the open
end is to the right (when you are facing the front
of the stove)
Inspect the Tudor for visible or concealed damage.
The unit should appear to be square and true. The
sheet metal parts should be smooth and free of
bends and dents. The enameled cast iron should be
free of chips or cracks. If visible or concealed
damage is found or suspected, contact your dealer
for instructions.
With the accessory box removed and set aside, take
care not to mar or chip the enameled legs, if
applicable. Have someone help lift the stove out of
the shipping box and set it into place.
The TEK Burner and TEK Fire logs supplied with the
Tudor are contained in the accessory box. The inner
refractory panels are wrapped and are in the firebox.
Always use great care when handling the decorative
fire logs and inner panels, as they are fragile and
subject to damage and breakage if handled roughly.
If a broken log or panel is encountered, contact your
dealer for replacements. Otherwise, set the logs and
panels aside until called for during the installation.
8
