HearthStone Quality Home Heating Products Inc
Tudor Model #8120
20
3)
Gently place the TEK burner in the
firebox. There are two locator tabs on
the left side and one on the right side.
Ensure these tabs find the mating slots
in the firebox sides. When installed it
should look like the figure below
4)
Place the Rear Log (1) in the firebox, on
the ember burner. On the underside of
the log there is a cutout that allows the
pilot flame to reach the front burner
under the log. Align the log in the
appropriate position. It should sit as
shown in the figure below.
5) Gently place the Front Log (2) in the
firebox, on the TEK Burner. On the top
of the TEK Burner there is a cutout that
allows the Front log to rest in place. It
should sit as shown in the next figure.
6) Re-install the glass assembly by lining
up the two tabs on the bottom of the
assembly with the two slots on the
firebox. Slide the lower portion of the
glass assembly into the slots and push
the top in against the firebox. Rotate
the clips into the “locked” position. Re-
install the front cast by sliding the upper
portion onto the lip of the top and tilting
the bottom in flush with the glass
assembly. It should then be snug in
place. Make sure the glass assembly is
properly secured to the firebox before
turning the unit on. Be careful not to
chip the enamel when installing the
glass assembly or front cast.
TEK Burner
Rear log
Front log
