3
Assembly
Oval
Before removing the oval stove from the skid, the flu body must
first be attached tothe stove back. Follow the instructions
below.
1) unscrew the flu body from the skid and set aside.
2) unscrew 3 sheet metal screws (2 along the bottom of the
oven at the bottom and 1 along left side - see illustration)
3)Remove the first level only of nuts and washers from the
screws extending out the back of the stove (7pcs)
4) place flu body on back of stove so that the nuts on the
screws fit inside the holes in the flange on each side of the flu
body.
5) while holding the flu body in place, attach the flu to the stove
by putting on a washer and nut on each screw, hand tight only.
6) install the sheet metal screws along the bottom and side of
the flu body, and tighten up.(3)
7) tighten up the remaining nuts (7)
back of stove
remove 3 sheet metal
screw before
installing flu body
do not remove these nuts
from the screws,
nuts
fit thru holes in flu body
only remove the first
level of nuts and
washers
reinstall 3 sheet metal
screw after installing flu
body
Warning: The stove is very heavy. Since the legs may dig into
a soft floor, do not locate the stove, or even set it to rest, on a
surface that could be imprinted.
We recommend that 3 or 4 persons be available to assist in the
lifting of the stove, and that gloves should be worn to protect
hands from cuts.
1)
First, remove the screws that are holding the flu body to
the skid and remove the flu body.
2)
Next, unscrew the two lag bolts which are securing the
front and back of the firebox base. Lighten the stove by
removing the keyplate and lids.
3)
Look under the oven and note that the stove must be lifted
up, over the wooden brace located there.
4)
With 2 persons on the heavier, firebox side (left), and one
person on the other side, lift the stove up, off of the skid and
onto its new location.
5)
If possible, have a fourth person remove the skid while the
others lift.
