6
Temperature Limiting Control
This heater is equipped with a Temperature Limiting Control. Should the heater reach an unsafe
temperature, the heater will automatically turn OFF. To reset:
1. Unplug the power cord from the outlet.
2.
Turn the ON/OFF switch on the CONTROL PANEL to OFF.
Wait 5 minutes.
3. Inspect the fireplace to make sure no vents are blocked, or clogged with dust or lint. If they are,
use a vacuum to clean the vent areas.
4. With the POWER switch in the OFF position, plug the power cord back into the outlet.
5. If the problem continues, have your outlet and wiring inspected by a professional.
FLAME +
FLAME “+”
: Makes flame effect brighter.
NOTE:
Flame effect stays on until power
button is turned off. Flame effect must be
on for heater to turn on.
2. 1.
Press once
. LED Indicator light turns
on, Flame effect brighter get ready to
adjust.
2.
Press again until desired setting is
reached
. Flame effect continues to get
brighter each time button is pressed.
HEATER
HEATER button
:
Turns
heater
on
and
off.
NOTE:
The
heater
only
works
when
the
flame
effect
is
on.
If
the
flame
effect
is
off,
the
heater
will
not
turn
on.
NOTE:
To
prevent
overheating,
the
heater
blows
cool
air
for
30
seconds
after
it
turns
off.
1.
Press once
. LED Indicator lights up.
Continue press Fan blows cool air for 30
seconds. Then Low heater turns on and
blows warm air.
2.
Press again
. LED Indicator lights up.
High heater turns on and blows hot air.
3.
Press again.
Heaters turn off.
The fan blows cool air, then turns off.
NOTICE
To improve operation,
aim
the remote control at the front of the fireplace.
DO NOT
press the buttons too quickly
. Give the unit time to respond to each command.
Remote Control Battery Information
This remote control uses two AAA
batteries
(Not included).
NEVER
dispose of batteries in
fire.
Failure to observe this precaution
may result in an
explosion
. Dispose of batteries at your local hazardous material processing center.
