15
1.
The control panel display is a multifunction visual display. It can provide a lot of information of the vehicle.
When the needle falls into the red sector, your batteries are low on power and need to be recharged
.
It is
wise to recharge your batteries when the needle enters the red zone. The remaining battery needle only goes
lower when using the battery, regardless the battery voltage. The remaining battery meter needle goes
higher only when recharging battery in progress.
Control Panel Display
2.
System will power off when the battery voltage is lower than 21.0V.
3.
System will be automatically power-off when the vehicle is not in use over 30 minutes. You need to remove
the key and insert the key to restart the scooter.
1.
The motors are designed to engage the electromagnetic brakes when the vehicle is not in use or when the
power is OFF. They also have a manual feature that allows them to “free-wheel” so the scooter can be
moved without turning it on. Free-wheeling is accomplished by adjusting the free-wheeling levers to the
free-wheeling position.
Free-Wheeling:
Warning !
Never free-wheel your power scooter on a slope.
Never free-wheel the motors while operating your vehicle.
Always remember to engage the motors before turning the power ON.
Free- Wheeling Lever
Summary of Contents for S34 Pixi
Page 9: ...9 TECHNICAL SPECIFICATIONS...
Page 10: ...10 PRODUCT DIMENSION...
Page 24: ...24 CIRCUIT DIAGRAM...
Page 25: ...25 BOM LIST DRAWING...
