Heat & Glo • 350TSI-P-CEM • 2033-973 Rev. G • 4/17
38
Figure 9.5 Proper Positioning and Securing of an Appliance
NAILING TABS
(BOTH SIDES)
PILOT HOLES
B. Installing the Non-combustible Board
The factory supplied non-combustible board must be used.
See Figure 9.3.
C. Securing and Leveling the Appliance
WARNING! Risk of Fire!
Prevent contact with:
• Sagging or loose insulation
• Insulation backing or plastic
• Framing and other combustible materials
Block openings into the chase to prevent entry of blown-
in insulation. Make sure insulation and other materials
are secured.
DO NOT
notch the framing around the appliance
standoffs.
Failure to maintain air space clearance could cause
overheating and fire.
The diagram shows how to properly position and secure
the appliance (see Figure 9.5). Nailing tabs are provided
to secure the appliance to the framing members.
• Bend out nailing tabs on each side.
• Place the appliance into position.
• Keep nailing tabs flush with the framing.
• Level the appliance from side to side and front to back.
• “Square” the unit by securing diagonal dimensions to
within 1/4 inch (0,64 cm) of each other. See Figure 9.4.
• Shim the appliance as necessary. It is acceptable to use
wood shims underneath the appliance.
• Secure the appliance to the framing by using nails or
screws through the nailing tabs.
• Secure the appliance to the floor by inserting two screws
through the pilot holes at the bottom of the appliance.
Figure 9.4 Positioning the Appliance Squarely
A B
Note: Diagonal dimensions (A) and (B) must be within
1/4 inch (0,64 cm) of each other.
Figure 9.3 Non-combustible Board
HEADER
NON-COMB BOARD