28
Heat & Glo • TIARA II-B • 7011-148 Rev. G • 10/12
8
Appliance Setup
A. Remove Shipping Materials
Remove shipping materials from inside or underneath the
fi rebox.
B. Top to Rear Vent Conversion
TOOLS REQUIRED:
Power drill; #2 Phillips bit; high-temp
sealant (optional).
Figure 8.1
Remove top grille, as highlighted.
Figure 8.2
Remove vent pipe adapter and gasket by remov-
ing 4 screws. Save the screws. (If gasket breaks, apply
high-temp sealant to bottom of adapter before installing as
shown in Figure 8.8.)
Figure 8.3
Remove the inner collar adapter.
Screws
Screws
Figure 8.4
Locate the knock out on rear of appliance.
Either remove the four screws holding the back shield in
place, saving the screws, OR break the seal on the knock
out and discard the knock out.
Figure 8.5
Remove rear access plate and gasket. Save
the screws.
CAUTION
Sharp Edges
• Wear protective gloves
and safety glasses during
installation.
Figure 8.6
Place cover plate and gasket over top vent and
attach with the four screws removed in Figure 8.2.
REAR PLATE
REAR PLATE
AND GASKET
AND GASKET
