35
Heat & Glo • TIARA II-B • 7011-148 Rev. G • 10/12
9
Operating Instructions
A. Before Lighting Appliance
Read this entire manual prior to using the appliance. Failure
to follow the instructions may result in property damage,
bodily injury, or even death.
WARNING
Glass door must be in place when appliance is
operating.
Risk of:
• Combustion
Fumes
• Fire
Do NOT operate appliance with glass door
removed.
• Open viewing glass for servicing only.
• Glass door MUST be in place and sealed before
operating appliance.
• Only use glass door certifi ed for use with appliance.
• Glass replacement should be done by qualifi ed
technician.
Improper installation, adjustment, alteration, service or
maintenance can cause injury or property damage. Refer to
the owner’s information manual provided with this appliance.
For assistance or additional information consult a qualifi ed
installer, service agency or the gas supplier.
WARNING
Do NOT use this appliance if any part has been under water.
Immediately call a qualifi ed service technician to inspect the
appliance and to replace any part of the control system and
any gas control which has been under water.
WARNING
•
Remove all shipping materials from inside and/or
underneath the fi rebox.
•
Review proper placement of logs, mineral wool.
•
Check the wiring.
•
Check the baffl e adjustment.
•
Ensure that there are no gas leaks.
•
Ensure that the glass is sealed and in the proper posi-
tion.
•
Ensure that the fl ow of combustion and ventilation air
is not obstructed (front grilles and vent caps).
B. Controls
FAN SPEED:
The blower is optionally installed on the
appliance and this knob controls the speed of the blower
that pushes the heated air into the room.
MAIN BURNER:
This control is used to turn the appliance
on and off.
PILOT IGNITOR
: The pilot ignitor is used only to start
the pilot. When the valve control knob is turned to the
pilot position and fully depressed press the piezo ignitor
repeatedly creating a blue spark directly next to the pilot,
igniting the pilot flame.
VALVE CONTROL
: This knob is used to control gas to
the appliance and for starting the pilot. There are three
positions,
ON, OFF, & PILOT
. The indicator on the valve
indicates the position of the knob.
COMFORT CONTROL
: This knob controls the flame height
from low (“LO”) to high (“HI”).
NOTE:
If using a remote control wall switch, or
thermostat, the On/Off Switch must be left “OFF”.
Turning the On/Off Switch to “ON” will keep the
appliance on continually.
HOT! DO NOT TOUCH
.
SEVERE BURNS MAY RESULT.
CLOTHING IGNITION MAY RESULT.
WARNING
• Keep children away.
• CAREFULLY SUPERVISE children in same room as
appliance.
• Alert children and adults to hazards of high temperatures.
• Do NOT operate with protective barriers open or removed.
• Keep clothing, furniture, draperies and other combustibles
away.
Glass and other surfaces are hot
during operation and cool down.
