Page 24
4/20/11
Heat & Glo • NorthStar EPA Fireplace • 480-1081E
The firebox of your fireplace is lined with high quality firebrick,
which has exceptional insulating properties. There is no need
to use a grate; simply build a fire on the firebox floor. Do not
operate the fireplace without bricks.
IMPORTANT:
The bricks are very similar in size. Be certain
you have the proper brick in the correct location. Measure
the brick size for accuracy.
After the coals are completely cooled, remove all old
firebrick and ash from unit and vacuum out firebox.
1. Remove new brick set from box and lay out to diagram
as shown in Figures 4.3 & 4.4
.
2. Lay bottom bricks in unit.
3. Install rear bricks on the top of the bottom bricks.
Slide top of bricks under clip on back of firebox wall
and push bottom of brick back.
4. Install side bricks. Slide top of brick under clips on
side of firebox and push the bottom of the brick until
it is flush with the side of the unit.
3
3
3
3
3
3
1
1
1
1
1
3
3
4
4
2
2
#
Brick Size
Qty. In Set
1 13-1/4” x 4-1/2” x 1-1/4”
5
2 13-1/2” x 4-1/2” x 1-1/4” w/ 1-1/2” chamfer
2
3 12” x 4-1/2” x 1-1/4”
8
4 12-1/2” x 4-1/2” x 1-1/4”
2
2. Firebrick Replacement
3
2
3
3
3
3
3
3
3
2
1
4
1
1
1
1
4
Use Part SRV7000-306 when ordering individual brick. Pro-
vide brick dimension or copy this page, mark the desired
brick and take it to your authorized dealer.
Figure 4.3 Fire Brick Configurations
Figure 4.4 Fire Brick Configurations
