31
Heat & Glo • SL-550TRSI-AUE • 2079-902 Rev. K • 10/08
!
!
OPERATING
CAUTIONS
• THIS APPLIANCE
M A Y E X H I B I T A
SLIGHT CARBON
DEPOSITION.
• D O N O T P L A C E
ARTICLES ON OR
AGAINST THIS AP-
PLIANCE.
• DO NOT USE OR
STORE FLAMMA-
BLE MATERIALS
NEAR THIS APPLI-
ANCE.
• D O N O T S P R AY
AEROSOLS IN THE
VICINITY OF THIS
APPLIANCE WHILE
IT IS IN OPERA-
TION.
Figure 46.
2.0 OPERATING INSTRUCTIONS
This appliance is a balanced fl ue heater and is de-
signed to operate with all combustion air being si-
phoned from the outside of the building and all exhaust
gases expelled to the outside of the building.
When lit for the fi rst time, the appliance will emit a slight
odor for an hour or two, due to paint and lubricants
used in the manufacturing process. For the fi rst few
minutes after each lighting, vapor may condense and
fog the glass and the fl ames may be blue. After a few
minutes this moisture will disappear and within 15-30
minutes the fl ames should become yellow.
The heater may produce a noise, caused from metal
expansion and contraction as it heats up and cools
down. This noise is similar to one that a furnace or
heat duct may produce and does not affect the opera-
tion or longevity of the heater.
WARNING: DO NOT CONNECT 240 VAC
TO THE GAS CONTROL VALVE OR CON-
TROL WIRING SYSTEM OF THIS UNIT.
The control system for this model includes a pilot,
electronic module, spark ignitor and thermocouple. It
consists of a 6V gas control valve/variable regulator
and an remote control. The controls are located in
the lower compartment behind the lower door, and
access is gained by lifting the door up. See Figure 1.
WARNING: THIS UNIT IS NOT FOR USE
WITH SOLID FUEL.
IGNITION
MODULE
(6V)
ON/OFF
WALL SWITCH
VALVE
FLAME SPARKER/
SENSOR
ANT.
REMOTE
CONTROL
HOT
NEUTRAL
GROUND
BATTERY PORT
VALVE
PILOT
IGNITION MODULE
6VDC
ON/OFF
SWITCH
THERMOCOUPLE
BLOCK
(CONNECTED TO
BACK OF VALVE)
GAS LINE
CONNECTED TO
BACK OF VALVE
PLUG IN
• THE DRESS GUARD IS FITTED TO THIS AP-
PLIANCE TO REDUCE THE RISK OF FIRE OR
INJURY FROM BURNS AND NO PART OF IT
SHOULD BE PERMANENTLY REMOVED. FOR
PROTECTION OF YOUNG CHILDREN OR THE
INFIRM, A SECONDARY GUARD IS REQUIRED.
• THE GLASS DOOR ASSEMBLY MUST BE IN
PLACE AND SEALED AND THE FIXED MESH
DRESS GUARD MUST BE IN PLACE ON THE
HEATER BEFORE THE UNIT CAN BE PLACED
INTO SAFE OPERATION.
• DO NOT USE THIS APPLIANCE IF ANY PART HAS
BEEN UNDER WATER. IMMEDIATELY CALL A
QUALIFIED SERVICE TECHNICIAN TO INSPECT
THE UNIT AND TO REPLACE ANY PART OF THE
CONTROL SYSTEM AND ANY GAS CONTROL
WHICH HAS BEEN UNDERWATER.
• DO NOT OPERATE THIS APPLIANCE WITH THE
GLASS DOOR REMOVED, CRACKED, OR BRO-
KEN. REPLACEMENT OF THE GLASS DOOR
SHOULD BE DONE BY A LICENSED OR QUALI-
FIED PERSON. DO NOT STRIKE OR SLAM THE
GLASS DOOR.
• THE GLASS DOOR ASSEMBLY SHALL ONLY BE
REPLACED AS A COMPLETE UNIT AS SUPPLIED
BY THE GAS HEATER MANUFACTURER. NO
SUBSTITUTE MATERIALS MAY BE USED.
