1.4 FEATURES
• Designed for cooling only.
• Powerful and quiet cooling.
• Top-down chassis for the simple installation and service.
1.5 CONTROL LOCATIONS
1.5.1 COOLING ONLY MODEL
• OPERATION
• VENTILATION
Push the lever to the "CLOSE" position to cool, heat or
recirculate room air only.
Pull the lever to the "OPEN" position to exhaust smoke or
stale air from the room.
This feature is best used in conjunction with the FAN ONLY
position.
• Side air-intake, side cooled-air discharge.
• Built in adjustable THERMISTOR and THERMOSTAT.
• Washable one-touch filter.
• Compact size.
—6—
PULL OPEN / PUSH CLOSE
REMOTE CONTROL SIGNAL RECEIVER
POWER
MODE
- Every time you push this button, the air conditioner alternates between COOL, MONEY SAVER
®
and FAN.
- MONEY SAVER:
• The fan stops when the compressor stops cooling. Approximately every 3 minutes the fan will turn on and the unit will
check the room air to determine if cooling is needed.
TIMER
- SHUT-OFF TIME
• You will usually use shut-off time while you sleep.
• With unit running, use Timer to set number of hours until
shut-off.
• For your sleeping comfort, once Time is set, the
Temperature setting will raise 2
°
F after 30 min., and 2
°
F
after another 30 min.
• Every time you push Timer button, it advances the Timer
setting as follows: 1 Hour
→
2 Hours
→
....
→
12 Hours
maximum.
- START TIME
• With unit not running, use Timer to set number of hours
before unit starts.
• Every time you push Timer button, it advances the Timer
setting as follows: 1 Hour
→
2 Hours
→
.....
→
12 Hours
maximum.
TEMPERATURE SETTING
• Use this button to automatically control the temperature of
the room.
The temperature can be set within a range of 60
°
F to 86
°
F by
increments of 1
°
F.
• To turn the air conditioner ON, push this button.
To turn the air conditioner OFF, push the button again.
• This button takes priority over any other button.
• When you first turn it on, the unit is in cool mode, at High
fan speed, and set at a temperature setting of 72
°
F.
FAN SPEED
• Every time you push this button, it advances the setting as
follows:
{High
→
Low
→
Med
→
High}
