3
SR468SE 27-06-13
1.
Component Identification and Assembly
Your San Remo Stove comes packed in a cardboard box/crate. Carefully remove any straps and
remove all cardboard and any plastic or wooden packaging, open the door and remove all the
contents. See List of Components section and check contents carefully.
Remove the coal catcher by lifting it up and rotating it until it can be removed through the open door
of the stove
Now lift up the baffle plate and rotate it and remove from the stove, long side first.
The flue collar can now be fitted to the top or back of the stove as desired using the M6 fixings and
washers provided. Thread each nut onto the screw first, then put on the washer and place the screw
through the fixing hole on the stove and finally screw onto the collar.
Fit the blanking plate to the opening that is not to be used in same way as described above for collar.
3
Installation Instructions
READ THESE INSTRUCTIONS CAREFULLY BEFORE INSTALLATION
It is very important to understand the requirements of the National Building Regulations (England
and Wales – Document J / Scotland - Part F/Document J (Republic of Ireland only) and standards BS
8303, BSEN 15287, along with any local regulations and working practices that may apply. Should
any conflict occur between these instructions and these regulations then the most stringent advice
must apply.
Health and Safety Precautions
Works must be carried out with care to meet the requirements of Health and Safety (Health and
Safety at Work Act 1974) and comply with the Health and Safety rules contained therein, and any
new regulations introduced during the lifetime of these instructions.
Handling
Adequate facilities must be available for unloading and site handling. San Remo Cassette Stoves are very
heavily built so always ask for assistance when lifting and siting the stoves.
Fire Cement
Some types of fire cement are caustic and should not be allowed to come into contact with the skin. In case
of skin contact, wash immediately with plenty of water.
Asbestos
This stove contains no asbestos. If there is a possibility of disturbing any asbestos in the course of
installation then please seek specialist guidance and use appropriate protective equipment.
Metal Parts
When installing or servicing this stove, proper care should be taken to avoid the possibility of personal
injury.
Important Chimney Warning
This stove must not be installed into a chimney that serves any other heating appliance.
Extractor Fan Warning
There must not be an extractor fan fitted in the same room as the stove as this can cause the stove to emit
fumes into the room.
Cleaning and Chimney Sweeping
The appliance, flue & chimney must be cleaned and checked internally and externally regularly in use
and especially after a period on disuse (e.g. after summer).
Lift down the baffle regularly to check for
