25
Glass Door Removal
Remove the top and bottom door by lifting up and away
from the unit.
Loosen the bottom 3 hex nuts.
Remove the 3 wings nuts and the top glass retainer
brackets.
Grasp the glass frame on each side and pull the as-
sembly away from the unit.
Cleaning Burner and Pilot
In order to properly clean the burner and pilot assembly,
turn off the gas to the unit and remove the logs exposing
the burner and pilot assembly.
Clean all foreign materials from top of burner. Check to make
sure that the burner orifice is clean.
Visually inspect the pilot periodically. Brush or blow away
any dust or linen accumulations. If the pilot orifice is plugged,
disassembly may be required to remove any foreign mate-
rial from the orifice or tubing. When the appliance is put
back in service check burner flame patterns with Figure 26.
Step 8. Positioning Logs,
Ember Material and Glass Doors
Placing the Ember Material
Ember material is shipped with this gas appliance. The bag
labeled Golden Embers (GE-93) is flame colorant material.
The bag labeled Glowing Ember (050-721) is standard
glowing ember material.
To place the ember material:
Loosen the bottom 3 hex nuts.
Remove the 3 wing nuts and the top door bracket.
Remove the glass door from the unit.
Cover the top of the burner with a single layer of ember
material. Then sprinkle GE-93 on top of the burner.
Save the remaining ember materials for use during
appliance servicing.
Replace the glass door and top bracket.
Tighten the hex nuts.
Replace the wing nuts.
Hand tighten the wing nuts.
Figure 26. Flame Patterns
GLASS SPECIFICATIONS: 33 x 12 1/2 CERAMIC
