08/04
4004-001 Rev C
5
PATIO CAMPFIRE INSTALLATION INSTRUCTIONS
1. Burner Assembly
a.
All Models
1)
Remove the burner assembly and check for
damage. Do not use damaged components.
2)
Position the burner assembly in the desired
location.
This location must be adjacent to the gas supply
line.
You must have easy access to the gas valve control
knob after it is installed and connected the gas
supply because the ON/OFF gas valve is used to
turn the burner on and off.
b.
Natural Gas Models
1)
Connect the ON/OFF gas valve of the appliance to
the incoming gas supply line. See Figure 1. Make
certain all gas connections are tight.
2)
Turn the ON/OFF valve at the appliance slowly to
the “ON” position. All connections must be tightened
and checked for leaks with a commercially
available, non-corrosive leak check solution. Be
sure to rinse off the solution when done leak testing.
c.
LP Gas Models
1)
Make sure the tank valve is turned completely off
(clockwise).
2)
Ensure the tank valve has the proper external mating
threads (tank valve marked “USE WITH TYPE 1”).
3)
Inspect the hose shipped with the appliance for
any damage. Do not use if there is evidence of
damage.
4)
Connect the end of the hose onto the ON/OFF gas
valve of the appliance. Make sure it is secured tightly.
5)
Connect the regulator assembly to the tank valve.
Hand tighten only (clockwise). Do not use a wrench
to tighten! Use of a wrench may damage the quick
closing nut and result in a hazardous condition.
See Figure 2.
6)
Position the hose out of pathways where people
might trip over it or in areas where the hose might
be subject to accidental damage.
7)
Open the tank valve fully (counterclockwise). Turn
the ON/OFF valve slowly to the “ON” position. All
connections must be tightened and checked for
leaks with a commercially available, non-corrosive
leak check solution. Be sure to rinse off the solution
when done leak testing. If a leak is found, turn the
tank valve off and do not use the appliance until
repairs can be made.
Figure 1
Natural Gas Burner Assembly
Figure 2
Propane Burner Assembly
