8
4004-001 Rev C
08/04
PATIO CAMPFIRE INSTALLATION INSTRUCTIONS
D. OPERATING INSTRUCTIONS
Inspect the burner before each use of the appliance. If there is any evidence that the burner is damaged, it must be replaced before
operating. See the Replacement Parts list on page 11.
Upon completing the gas line connection, a small amount of air will be in the lines. When first lighting the burner, it will take a few
minutes for the lines to purge themselves of this air. Subsequent lighting of the appliance will not require such purging.
Never allow
the ON/OFF valve to remain in the open position without placing a burning match on top of the burner FIRST!
FOR YOUR SAFETY, READ BEFORE LIGHTING
WARNING!
If you do not follow these instructions exactly, a fire or explosion may result causing property damage,
personal injury and/or loss of life.
A.
This appliance must be lit by hand. When lighting, follow
these instructions exactly.
B. Before lighting,
smell all around the appliance area for
gas. Be sure to smell next to the base of the appliance
because some gas is heavier that air and will settle on
the floor.
WHAT TO DO IF YOU SMELL GAS:
•
Do not try to light any appliance.
•
Do not touch any electric switch; do not use any phone in
your building.
•
Immediately call your gas supplier from a neighbor’s
phone. Follow the gas supplier’s instructions.
•
If you cannot reach your gas supplier, call the fire
department.
C.
Use only your hand to turn the gas control knob or valve.
Never use tools. If the valve will not turn by hand, don’t try
to repair it, call a qualified service technician. Force or
attempted repair may result in a fire or explosion.
D.
Do not use the appliance if any part has been under
water. Immediately call a qualified service technician to
inspect the appliance, and to replace any part which has
been under water.
Turn the ON/OFF valve to the “OFF” position at the appliance for a natural gas appliance.
For an LP appliance, turn the ON/OFF valve to the “OFF” position at the appliance and then turn the valve on the LP tank
clockwise to the “OFF” position.
TO TURN OFF GAS TO APPLIANCE
1. Stop!
Read the safety information above.
2.
Remove the cover.
3.
Find the manual gas control valve.
4.
Place a burning match on top of the burner in the middle
where ports are present.
DO NOT HOLD THE MATCH IN
YOUR HAND!
For a natural gas appliance turn on the ON/
OFF valve slowly at the appliance. For an LP appliance
turn the valve on the LP tank counterclockwise all the way
and then turn on the ON/OFF valve slowly at the appliance.
5.
If the burner does not light before the match goes out,
immediately turn the gas valve to “OFF”.
6.
Wait at least five minutes to clear out any gas. Then smell
for gas, including the base of the appliance. If you smell
gas,
STOP!
Follow “B” in the safety information above. If
you do not smell gas, repeat Step 4.
LIGHTING INSTRUCTIONS
