5
Safety Instructions
container . To protect against electrical hazards,
DO NOT
immerse in water or
other liquids .
• DO NOT
touch the control panel or plug with a wet hand .
• DO NOT
run cord under carpeting .
DO NOT
cover cord with throw rugs, runners or
similar coverings. Arrange cord away from high traffic areas and where it may be a
trip hazard .
• DO NOT
insert or allow foreign objects to enter any ventilation or exhaust opening
as this may cause an electric shock or fire, or damage the heater.
•
To prevent a possible fire,
DO NOT
block the air intakes or exhaust in any manner .
DO NOT
use on soft surfaces, like a bed, where openings may become blocked .
• A heater has hot and arcing or sparking parts inside .
DO NOT
use in areas where
gasoline, paint, explosive and/or flammable liquids are used or stored. Keep unit
away from heated surfaces and open flames.
• Avoid the use of an extension cord because the extension cord may overheat and
cause a risk of fire. However, if you have to use an extension cord, the cord shall be
2.5mm
2
minimum size .
•
To avoid fire or shock hazard, plug the unit directly into a 220-240V and 13A
electrical socket outlet .
• To disconnect heater, turn controls to
OFF
, then remove plug from outlet. Pull firmly
on plug,
DO NOT
unplug by pulling on the cord .
• Always unplug the unit before moving or cleaning, or whenever the heater is not
in use .
• Use only for intended household use as described in this manual . Any other use
not recommended by the manufacturer may cause fire, electric shock, or injury
to persons . The use of attachments not recommended or sold by unauthorized
dealers may cause hazards .
• Always use on a dry, level surface . Use on ceiling only .
• WARNING
: To reduce the risk of fire or electric shock,
DO NOT
use this unit with any
solid-state speed control device.
• DO NOT
attempt to repair or adjust any electrical or mechanical functions on
this unit . Doing so will void your warranty . The inside of the unit contains no user
serviceable parts. Qualified personnel should perform all servicing only.
• Connect to properly grounded outlets only .
• The heater must not be located in front of a socket outlet .
• SAVE THESE INSTRUCTIONS .
Summary of Contents for 902112
Page 6: ...6 Product Diagram Product Diagram...
Page 11: ...11 Customer Service...