8
HEATER STARTING PROCEDURES
• CONFIRM THAT TRAILER IS POSITIONED CORRECTLY.
• TO OBTAIN MAXIMUM FUEL UTILIZATION FROM TANK, THE TONGUE OF THE TRAILER
SHOULD BE TILTED SLIGHTY TO THE GROUND.
• AFTER SUCCESSFUL STARTING OF THE GENERATOR PLUG IN FUEL TANK IMMERSION
HEATER (LOCATED NEAR FRONT OF TANK)
• SET THE CONTROL KNOB TO ZERO POSITION (SEE ITEM 2, SPEC PAGE 3)
SWITCH THE 220V BREAKER ON THE GENERATOR TO THE ON POSITION, THIS WILL
SEND POWER TO THE FUEL FILTER PREHEATER.
• IF BELOW 30 F, WAIT AT LEAST 15 MINUTES FOR FUEL HEATERS TO WARM THE FUEL.
• ADJUST TEMPERATURE SETTING ON REMOTE THERMOSTAT TO DESIRED SET POINT.
• MAKE SURE INLET PORTS ARE FREE OF SNOW, ICE OR ANY DEBRIS
• TURN THE CONTROL KNOB TURN TO THE FLAME ICON
• BURNER BLOWER WILL START AND COMMENCE PRE PURGE SEQUENCE
• IF BURNER DOES NOT FIRE, PUSH RESET BUTTON ON BURNER
• AFTER THE BURNER FIRES UP, BLOWER FANS WILL START AFTER 2 TO 3 MINUTES.
IF AFTER 3 ATTEMPTS TO START BURNER, DO NOT PUSH RESET AGAIN, THIS WILL
CAUSE FUEL LOADING IN THE COMBUSTION CHAMBER.
REVIEW TROUBLESHOOTING ON PAGE 12.
TO STOP HEATER TURN CONTROL KNOB TO ZERO POSITION AND WAIT UNTIL BLOWER
FAN COMPLETES COOLING DOWN THE COMBUSTION CHAMBER (10 MIN)
DO NOT DISCONNECT POWER CORD, SWITCH BREAKER TO OFF POSITION OR SHUT
DOWN GENERATOR WHILE FAN IS OPERATING
Summary of Contents for VF900SC The Dragon Wagon
