Call 1-877-744-3649 for assistance or email us at service@phoenixinno.com
.
3
MC
GROUNDING INSTRUCTIONS
This product must be grounded. If it should malfunction or break down,
grounding provides a path of least resistance for the electric current to reduce
the risk of electric shock. This product is equipped with a cord with an
equipment-grounding conductor and a grounding plug. The plug must be
plugged into an appropriate outlet that is properly installed and grounded in
accordance with all local codes and ordinances.
DANGER:
Improper connection of the equipment-grounding conductor can result in a risk
of electric shock. Check with a qualified electrician or service technician if you
provided with the product-if it will not fit the outlet, have a proper outlet
installed by a qualified electrician.
This product is for use on a nominal 120V circuit and has grounding plug that
looks like that plug illustrated below. Make sure that the product is connected
to an outlet having the same configuration as the plug. No adapter should be
used with this product.
NOTE:
A 15AMP,120 Volts circuit is required. Dedicated circuit is preferred but not
essential in all cases, a dedicated circuit will be required if, after installation,
the circuit breaker trips or the fuse blows on a regular basis when the heater
is operating. Additional appliance on the same circuit may exceed the current
rating of the circuit breakers.
WARNING:
1. Ensure the power cord is not installed so that it is pinched or against a
sharp edge and ensure that the power cord is stored or secured to avoid
tripping or snagging to reduce the risk of fire, electric shock or injury to
persons.
2. Construction and electrical outlet wiring must comply with local building
codes and other applicable regulations to reduce the risk of fire, electric
shock and injury to persons.
Do not attempt to wire your own new outlets or circuits. To reduce the risk of
fire, electric shock or injury to persons, always use a licensed electrician.
SPECIFICATIONS
Technical Specifications
Model: WW13014
Voltage: 120V
Frequency: 60Hz
Power: 1500W
OPERATING INSTRUCTIONS:
BEFORE USING THIS APPLIANCE:
1.Before permanently placing your Infrared heater, plug it into a convenient
outlet to verify that the circuit breakers for the outlet are on.
2.The information regarding this appliance can be found on the rating plate
located on the back of the unit.
PLUGGING IN THE HEATER:
1. Plug the unit into an outlet with no less than 15Amp/120V.
Read all instructions and warnings prior to operating the appliance.
Ensure that all controls are in the “OFF” position before plugging the
appliance in to a properly grounded electrical outlet. The control panel of the
appliance is located, (See Fig. 1 and Fig. 2).
`
When you first turn the heater on, it may emit a slight but harmless odor.
This odor results from certain oils or greases being heated as the appliance
is used for the first time. This odor is perfectly safe and will stop shortly – it
will not reoccur after the first operation of the appliance.
WAVE
HEAT
Fig. 2
Fig. 1
72
Grounded Outlet
Grounded Outlet Box
Grounding Pin
