GB
Specifications
Model:
LDHR009-200KB
Voltage (V):
220-240V
~
Power consumption (W):
2000W (660, 1000, 1320, 1600, 1760, 2000W)
IP-class:
IP65
Remote
control:
Yes
Battery
type:
2xAAA
I O II Switch function
I = Standby
Use the remote control to turn ON/OFF the heater.
II = ON
The heater works directly without remote control.
O = OFF
Power OFF.
Remote control instructions
Operation instruction
•
Remove all package material (including anti-vibration object of the lamp) and check the appliance,
supply cord and the plug for signs of damage.
•
Pay attention to the mounting place and all mounting material (dowels and screws). Ensure they are
suitable and stable enough for mounting and lastingly holding of the appliance.
•
Before mounting, the minimum safe mounting distances and tilt angles shown in the figures must be
strictly followed.
•
The distance between the bottom edge of the appliance and the floor must be at least 1.8 m. See
figure 2.
•
There must be a distance of at least 0.25 m between the appliance and the ceilings, roofs or other
covers. See figure 2.
•
There must be a distance of at least 0.5 m at each side between the appliance and walls or the like.
See figure 2.
•
Recommended degree to mounting surface is 45°. See figure 3.
•
Pay attention that the installation of the appliance must not add excessive wind load.
•
First fix the mounting bracket on the wall. Ensure that the place to be installed is secure and firm if not
install the appliance to a stand.
•
Adjust the desired angle of radiation and tighten all screws. Check regularly the screw’s connection.
Mechanical bearing pressure and oscillation due to wind or rain could lead to loose.
4 5
Button
Description
Function
Up Arrow
Up one heating level
Max
The heater goes directly to the
highest
heating
level.
Down Arrow
Down one heating level
ON
To swith the heater ON press ON. The patio
heater has a soft start function of 33% power.
4 seconds after the heater has been turned
ON it will automatically switch to the last
heating level used. In case of the first time
use, after 4 seconds the heater will
automatically swith to 100% power.
OFF
To switch the heater OFF press OFF. The heater
will switch to standby mode (the receiver indicator
will
light
up).
